¶ LeetDMA Tool Firmware Burning Guide
¶ Step 1: Launch the Tool
- Run the
LeetDMA Tools V2.exeapplication.
¶ Step 2: Install the Driver
-
Click on Driver Installation in the top-left corner.
-
Select Install and wait approximately 10 seconds for the driver installation to complete.
¶ Step 3: Flash the Firmware
-
Click on the white square in the upper-right corner to open the file browser.
-
Select the firmware you wish to flash from the menu.
-
Click Start to begin the burning process. Once it displays Update Complete, the burning is successful.
-
Restart the PC and switch the cable back to the data port.
¶ Step 4: Finalize the Process
- After successfully burning the firmware, restart the PC.
- If the speed test is not available after one restart, try restarting the PC again, as two restarts may be necessary to properly disable DMA.
- Once the speed test is available, the burning process is successfully completed.