¶ Setup Instruction
⚠ Do not upgrade your firmware if your box was not activated before 2024.8.31.
Normal upgrading is supported if your box was activated before 2024.8.31.
» Preparation
Set up your Kmbox B+ as shown in the image below:
Note: If you are gaming on a single PC, cables plugged into "port serial" and "controlled PC" should both be connected to the gaming PC.
» Install Network Adapter Driver
After plugging the cable into the Net port, a disk will appear as shown in the picture below.
Double-click the disk and run the .exe file inside.
If no disk can be found, download the driver manually.
» [Click me to download Driver]
» Change Your Network Adapter IP Address
Open Control Panel -> Network and Sharing Center
Change the IP Address
» Check if Ping is Successful
Run cmd.exe
Check if the IP on the kmbox can be successfully pinged
Copy
ping 192.168.x.x(IP on your kmbox)
If the above is shown, the box is ready. Now you can refer to your dma software for further instructions.